![]() In s some rare cases I encounter the problem with actually seeing the crosshair. You always point the telescope where you want and where the crosshair is. They are perfect because when they are aligned with the OTA correctly, they are excellent with high-magnification eyepieces. My personal preference is the proper finder scope, which is a little refracting telescope with a crosshair inside the eyepiece. So I hate it, and I always replace these red dot finders on the telescopes with proper finder scopes. You have to look from the same position as you did during the alignment with the optical tube. ![]() But my issue is that if you are trying to locate something and you point the telescope, especially with high magnification, when looking from slightly different angles the red dot is moving all over the place. The LED is shining on the small lens, in some cases only glass at the front and creating a little red dot in the middle. I know that there are many types of these devices, but the principle is the same. Let alone the issues with the red dot finder I don’t like using it. Here is the helpful thread on the cloudynights forum where you can find a complete guide with pictures on how to take it apart and fix it. Repeating turning the on and off the LED can also create an issue with the switch. But if the finder scope stops working after a while and it is not in the warranty anymore, check the inside. If it is from the box, just contact Celestron, and they will send you a new one. All you have to do is to remove a few screws to inspect all the inside parts.Īctually, that is more often the issue with the Celestron Star Pointer finder scope. It can be a loose wire or something burnt. If you check that and there is nothing wrong with the battery pins, it must be something inside. The problem can be somewhere else, of course. So, if you have an issue with the red dot finder, check the battery pins and contact points first. I took the red dot finder completely apart at first to see if something is wrong with the electronics inside. In my case, I discovered that there was a simple problem with an even simpler solution.īut I didn’t locate this problem right away. Don’t worry, Celestron will exchange it for the new one, which is not a big problem. It is common with Celestron Star Pointer finder scope not working from the box. The red dot finder stopped working, or it has not been working since the telescope purchase. ![]() And it is a very simple device with an LED that is almost indestructible.Īfter some google research, I found out that many people have the same problem. It was strange because I remembered that it was working perfectly when I used it last time. But to my surprise, when I replaced the old battery with the new one, the red dot finder was not working. I remembered that it had a working red dot finder, so I planned to remove it from the telescope and attach it to the toe shoe on the DSLR. So I went into the garage and took my old telescope (Bresser 70AZ Reflector) that was sitting there for a few years. It should help with aligning and framing the objects I’m shooting. One day, I decided that I would mount Red Dot Finder from my old telescope to my DSLR camera. I may receive a commission for purchases made through these links. This site contains affiliate links to products. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |